JCM Part No . 960 - 000044R _ Rev . 2 © 2007, JCM American, Corporation 3 WBA - SS Chassis Modification Intelligent Cash Box (ICB) System Installation - Retrofit Kits 4 Installation - Retrofit Kits WBA - SS Chassis Modification It may be necessary to drill a hole in older WBA - SS frames to allow communication with an ICB Cash Box ( See Figure 5) . Required tools are an electric drill, a 5mm drill bit, and the template shown in Figure 6 .    Retrofitting an Existing Cash Box This change is made by: 1 . Drilling out the two existing 3/16” rivets securing the handle and remove it, then 2 . Lining up the new ICB handle assembly (Part No . 067083) and install it by using the new 3/16” rivets (Part No . 148 - 000001) provided in the kit . (See the Figure 7 box comparison photos) . Figure 4 Printer Station Part No . 501 - 000072R The Printer Station contains a TPS - 200 (Manual Part No . 960 - 000051) . It prints the Machine Number Set tickets and soft count tickets when the Cash Box is placed on the Docking Station . It has a CPU board that requires an EPROM . It has harnessing for connection to the Docking Station Tool . Depending on the Count Sort Machine used, the printer type will very . NOTE: Make sure the latest software version is installed in the unit . Printer Station Figure 5 Drill Hole Requirement Figure 6   Drill Hole Template Part No . 501 - 000055 NOTE: Make sure to blow out any metal drill shavings that accumulate to prevent damage to the Cash Box mechanism . Figure 7 Cash Box Type Comparison ICB MetalCash Box      Standard MetalCash Box 500 Note Plastic Cash Box    1000 Note Plastic Cash Box