JCM Part No . 960 - 000044R _ Rev . 2 © 2007, JCM American, Corporation 5 Swivel Plate (F - swivel plate) Intelligent Cash Box (ICB) System Retrofitting the WBA - 12/13 - SU 6 Retrofitting the WBA - 12/13 - SU Swivel Plate (F - swivel plate) 1 . Remove the two (2) E - rings securing the swivel plate in place ( See Figure 14 a) . 2 . Remove the screw securing the ground wire standoff on the side of the transport and remove the last E - ring ( See Figure 14 b) . 3 . Slide the shaft out of the transport to replace the existing swivel plate . 4 . Place the black mylar sheet (Part No . 079648) over the backside of the optical board (Part No . 079646), and secure the board to the new swivel plate (Part No . 086639) . Make sure the mylar sheet is posi - tioned as shown in Figure 15 a . 5 . Slide the rod back through, slipping the new swivel plate and spring over it . 6 . Replace the E - rings onto the rod . 7 . Secure the harness (Part No . 079485) onto the Swivel Plate with a Cable Tie before threading it to the circuit board . Tie it off on the Stand - off Plate ( See Figure 16) . 7 UBA Module The ICB Module plugs into the bottom of the UBA CPU Board, and is secured in place under a cover plate ( See Figure 17) . Figure 13 Mounting the Optical Interface Board Figure 14 Swivel Plate E - ring Removal a b NOTE: Remember that the stand - off plate on the side of the transport unit goes under the E - ring . Figure 15 Black Mylar Sheet Placement a b Bottom View Top View Mylar Sheet Figure 16 Cable Tie Secured to Harness to Plate Figure 17 UBA ICB Module Location UBA ICB Module