JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 2 - 3 Installation/Operation AD - 02™ Retrievable Bill Validator Section 2 5 . Check operation by inserting bill types of each denomination to verify that each bill is accepted and properly credited by the host machine and that the correct bill(s) are dispensed . Bill Condition Considerations Bulk Bill Loading: When loading officially sealed bills, loosen the bundle first by fanning the bill before inserting them . Circulated Bills Do not use dirty, wet, wrinkled or any bills in the conditions illustrated in Figure 2 - 8 . Stacker Loading To load the Stackers manually perform the follow - ing steps: 1 . Open the AD - 02™ front door (See Figure 2 - 9) . 2 . Insert the bill - stacking tool into one of the Stackers ( See Figure 2 - 10) . Make sure the tool is inserted into the Stacker as far as it will go ( See Figure 2 - 11) . Figure 2 - 7 Dispensing Slot LED Indicators Dispensing Dispensing Slot Slot LEDs (Blinking) Figure 2 - 8 Poor Bill Condition Examples Figure 2 - 9 Opening AD - 02 Front Door Figure 2 - 10 Inserting Stacking Tool