JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 2 - 6 Section 2 AD - 02™ Retrievable Bill Validator Installation/Operation 5 . To clear a Jam in the Transport area, lift up and out on Flat Metal Bar Release Lever #6 ( See Figure 2 - 21 a, b & c), then lift open the Transport door and remove the Jam . 6 . To remove a bill jam behind rear plastic door #8, pull down on the corresponding horizon - tal Green Locking Bar (See Figure 2 - 23 a), open the related Transport area door, remove the jammed bill and reclose the door . 7 . To remove a bill jam behind any of the rear transparent plastic doors (#9 through #11), lift up on the corresponding horizontal Green Locking Bar ( See Figure 2 - 23 a, b & c), open the related Transport area door(s), remove the jammed bill and reclose door(s) . Figure 2 - 20 Accessing the Validator Area Release Lever #4 Open Press a b c Forward Release Lever #5 Press Forward Figure 2 - 21 Accessing the Transport Area Open Release Lever #6 Lift a b & Open Remove Jam c NOTE: It is possible that a bill can get jammed in the rear transport section of the machine during the insertion or dispersal process . A jammed bill in this section is easily detected through the clear plastic access doors (See Figure 2 - 22) . Figure 2 - 22 Rear Access Plastic Doors Clear Plastic Windows in Doors Figure 2 - 23 Accessing the Rear Transport Area Release Bar #8 & Remove Pull Down a b c Open Upward Release Bar #9 & Lift Up Open Downward Bill Jam & Reclose Doors