JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 4 - 5 Disassembly/Reassembly AD - 02™ Retrievable Bill Validator Section 4 5 . Raise the tabs from the two (2) Ground Contact Fittings located on each side of the Expanded Stacker (See Figure 4 - 13 inset) and lift unit to separate it from lower section . 6 . Remove the Expanded Stacker up and off the lower Stacker Assembly as indicated by the large arrow illustrated in Figure 4 - 13 . Upper Standard Stacker Removal Perform the following steps to remove the AD - 02™ Upper Standard Stacker Unit from the top of the Stacker Assembly: 1 . Bend the two (2) Soft Wire Clamps open and remove the enclosed 2 - wire and 4 - wire bundles from them (See Figure 4 - 14 a) . 2 . Remove the three (3) screws securing the first Standard Stacker to the lower stacker section set (See Figure 4 - 14 b) . 3 . Lift the tabs from the two (2) Ground Contact Fittings located on each side of the Standard Stacker (See Figure 4 - 14 inset) and raise up to separate from lower section . 4 . Remove the Standard Stacker up and off the lower Stacker Assembly as indicated by the large arrow illustrated in Figure 4 - 14 . Lowest Standard Stacker Removal Perform the following steps to remove the AD - 02™ Lowest Standard Stacker Unit from the top of the Base Unit Assembly: 1 . Bend the two (2) Soft Wire Clamps open and remove the enclosed 2 - wire and 4 - wire bundles from them (See Figure 4 - 15 a) . 2 . Remove the four (4) screws securing the last Standard Stacker to the Base Storage Unit section (See Figure 4 - 15 b) and remove the Gear Cover (See Figure 4 - 15 c) . 3 . Lift the tabs from the two (2) Ground Contact Fittings located on each side of the Lower Standard Stacker (See Figure 4 - 15 inset) and raise up to separate from lower section . 4 . Remove the Lower Standard Stacker up and off the Base Storage Unit Assembly as indicated by the large arrow illustrated in Figure 4 - 15 . Base Storage Unit Removal Perform the following steps to remove the AD - 02™ Base Storage Unit Assembly: 1 . Pull the Base Storage Unit Release Lever forward (See Figure 4 - 16 a) and pull the Base Storage Unit all the way out of the Base assembly as indicated by the large arrow illustrated in Figure 4 - 16 . 2 . Insert a flat - head screwdrivers into one of the two (2) latch holes (See Figure 4 - 16 b) and lift up on the latches while pulling the Base Storage Unit forward to separate it from the bottom base section . 3 . Remove the Wire Bundle Cover mounting screw, and pull the Wire Bundle Cover from the base storage until the Base Storage Unit is free of the Base section . a) a) b) b) b) Figure 4 - 14 Upper Standard Stacker Removal a) a) b) b) b) b) c) Figure 4 - 15 Lower Standard Stacker Removal