JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 4 - 1 8 Disassembly/Reassembly AD - 02™ Retrievable Bill Validator Section 4 10 . Remove E - ring #2, the 25 Tooth Gear and Locking Pin #2 (See Figure 4 - 60 d) . 11 . Remove E - rings #3 and #4, Shaft Bearings #1 and #2 and the Drive Shaft ( See Figure 4 - 60 e) . 12 . Remove the two (2) Transfer Plate Sensor mounting screws and remove it from the frame ( See Figure 4 - 61 a) . 13 . Remove the two (2) screws securing the Motor Mounting Plate and remove it from the frame ( See Figure 4 - 61 b 1 and b 2 ) . 14 . Remove the Transfer Plate Sensor ( See Figure 4 - 61 c) . 15 . Remove the Corner Screw and remove the structural Support Shaft ( See Figure 4 - 62 a) 16 . Cut the Cable Tie and unplug the In - line Connector ( See Figure 4 - 62 b 1 and b 2 ) . 17 . . Remove the two (2) motor mount Screws, and the Transfer Motor from the frame ( See Figure 4 - 62 c 1 and c 2 ) . 18 . Cut the Cable Tie and unplug the In - line Connector ( See Figure 4 - 63 a 1 and a 2 ) . 19 . Remove two (2) screws, and the Lifter Motor from the frame ( See Figure 4 - 63 b 1 and b 2 ) . 20 . Remove E - ring #1, the Tension Spring and Spacer Collar from the shaft ( See Figure 4 - 64 a) . 21 . Remove E - ring #2, the Cam, Locking Pin #1, 36 Tooth Gear, Locking Pin #2, and the Shaft Bearing ( See Figure 4 - 64 b) . 22 . Remove E - ring #1, the Tension Spring and Spacer Collar from the shaft ( See Figure 4 - 65 a) . 23 . Remove E - ring #2, the Right Side Cam, Locking Pin, Shaft Bearing, and Lifter Shaft from the frame ( See Figure 4 - 65 b) . b) c 2 ) c 1 ) d) a) Figure 4 - 59 Base Unit Discharge Motor Removal a) b) c) d) e) Figure 4 - 60 Base Unit Drive Shaft Removal Figure 4 - 61 Transfer Plate Sensor Removal c) a) b 1 ) b 2 ) Figure 4 - 62 Transfer Motor Removal a) b 1 ) b 2 ) c 1 ) c 2 )