JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 6 - 1 0 Section 6 AD - 02™ Retrievable Bill Validator Programming and Testing Test #7 (part d7) — AD - 02 Error Log Downloading Procedure Perform the following steps to download the AD - 02™ Error Log: 1 . Connect a serial cable between the AD - 02™ and an available Windows PC Comm Port . 2 . Set DIP Switches #1, #2, and #8 to ON and apply power to the unit . 3 . On the Windows desktop, click on the Start Screen Button (See Figure 6 - 26) . 4 . Click on the Programs , then Accessories , and then on Communications pull - down menus respectively, then 5 . Click on the “Hyper Terminal” text line . 6 . On the opening “Hyper Terminal” Screen, type a Name in the area provided . 7 . The first I con is already selected, and may be used . Click on the OK Screen Button . 8 . The Connect To Screen will now appear . On this screen ignore all of the boxes except the Connect Using: pull down menu . 9 . If a port other than COM1 is being used, select the new port from the Connect Using: drop down menu and click on the OK Screen Button again . 10 . The Figure 6 - 27 Com’X’ Properties/Port Set - tings Screen will now appear . Change the port setting values shown as follows: a . Bits per second: = 9600 b . Data bits: = 8 c . Parity: = Even d . Stop Bits: = 1 e . Flow control: = None 11 . Click on the OK Screen Button . 38 Pusher Motor error 39 Dispenser belt home motion error 40 Holding tray error - Full 41 Bin 1 empty 42 Bin 2 empty 43 Bin 3 empty 44 Bin 4 empty 45 Transport Motor lock - up 46 Dispenser reject error 47 Dispenser Motor error 48 Lifter Motor lock - up 50 Function Check error 51 Validator Head error 52 Bin 1 level error 53 Bin 2 level error 54 Bin 3 level error 55 Bin 4 level error 56 Open Door error 57 Unit withdrawn out of housing error 60 Long Note error 61 Short Note error 62 Overlapping Note error 63 Linked Note error Table 6 - 6 Test ‘d6’ Error Code Listing (Continued) Error Code Description NOTE: If the PC does not have Hyper Terminal installed, contact your IS Department and have them install it from the Primary Windows Application disk . Figure 6 - 26 Connection Description Screen Figure 6 - 27 Connection To Screen