JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 6 - 1 5 Programming and Testing AD - 02™ Retrievable Bill Validator Section 6 Test #13 — Software Version Display Test Test #13 is provided to display the current Soft - ware Version resident in the AD - 02™ Unit . To retrieve the current AD - 02™ software version resident in memory proceed as follows: 1 . Press Status Switch SW1 until test T13 is displayed (See Figure 6 - 40 a), then 2 . Press SW3 . The software version is displayed at approximately 0 . 5 second intervals, scrolling from right to left ( See Figure 6 - 40 b) . 3 . Press SW1 to end the test . Test #14 — Data Set - Up Test Test #14 enables the selection of data read/right operations via DIP Switch SW - 1 settings . To conduct a Data Set - Up Test proceed as follows: 1 . Begin the test by setting DIP Switch SW - 1 Switch 1 to OFF and Switch 8 to ON (See Figure 6 - 41 a on Page 16 of this Section) . 2 . Press Status Switch SW1 until T14 is displayed (See Figure 6 - 41 b), then 3 . Press SW3 and select the data field that requires changing ( See Figure 6 - 41 c) . 4 . Press SW1 to determine the data to be changed ( See Figure 6 - 41 d) . 5 . Press SW1 and SW2 to adjust the data of the selected field ( See Figure 6 - 41 e) . 6 . Press SW3 to write the data into memory ( See Figure 6 - 41 f) . 7 . Power down the AD - 02™ to end this test . Test #15 — Cleaning Mode Test #15 allows the unit to cycle a Alcohol treated piece of dedicated Cleaning Paper (Part No . 900 - 100843R) through all of the bins in the unit . After cycling through all the bins, the cleaning paper will reappear at the bill output dispensing slot . To perform this Cleaning Mode Test, prepare a Alcohol wetted dedicated Cleaning Paper (Preview Figure 6 - 44 to correctly apply solution to paper according to Step 2 of   Cleaning Card Mode Acti - vation on page 6 - 16) and follow Figure 6 - 42 steps a through e . Figure 6 - 40 Software Version Display Test Press SW1 to Locate Test Press SW3 to Display Version b c Aging Count a Press SW1 to End Test NOTE: The software version is displayed at approx - imately 0 . 5 second intervals, scrolling from right to left . T         1          3 NOTE: This operation can only be completed in Write Mode! NOTE: Ensure that “WROK” (Write OK) is displayed before ending the data writing procedure . Begin the test by setting DIP Switch SW1 Switch 8 to ON and apply power to the unit . Press SW1 to Locate Test Press SW3 to Select Data No . to Change Press SW1 to locate the Data requiring change . Press SW1 and SW2 to set the Desired Data Value . Press SW3 to Write Data into Memory . b c d No .        r          d        Data a Power down the AD - 02 to end this test . Data Set - Up Test Initial Switch Block SW1 Data Selection Table No . Setting Item Adjustment Range 1 Dispensing Length 1 to 5 * 2 N/A 3 N/A * Adjustment Range = 1 (small) to 5 (Large) . Initial Setting = 3 e f T          1          4 Switch Settings See Table Below No .       w          r       Value NOTE: Ensure that “WROK” (Write OK) is displayed before ending the