INDE_80

JCM Part No . 960 - 000053R _ Rev . 6 © 2007, JCM - American Corporation 6 - 1 6 Section 6 AD - 02™ Retrievable Bill Validator Programming and Testing Cleaning Card Mode Activation To begin this portion of the test proceed as follows: 1 . Record the switch settings currently set on DIP Switch SW1 and follow Figure 6 - 43 procedural Steps a to e . 2 . Apply a 50% Ethyl Alcohol cleaning solution to the front and back of a standard AD - 02™ cleaning sheet inside the broken line shown in Figure 6 - 44 (JCM Part No . 900 - 100843R) . 3 . In a single cleaning sequence, pass the sheet three or four times repeatedly through the machine from the Entry Slot to the Exit Slot ( See Figure 6 - 45) . Counting Sensor Adjustment (Part 1) Prior to re - adjustment, dust off all Sensor surfaces . Figure 6 - 46 provides the steps and display results necessary to begin performing this test . Figure 6 - 42 Cleaning Mode Procedure Press SW1 to Locate Test . Press SW3 to Begin the Cleaning Process . Insert the dedicated cleaning paper into the Bill Entry Slot . Once cleaning is complete, remove the cleaning paper from the Dispensing Slot . Press SW1 to End the Test . a b C L n c d NOTE: Make sure that “CLN” is displayed and initialization is complete before proceeding to next step! e NOTE: Insert only one piece of cleaning paper at a time . T 1 5 WARNING: Cleaning is required every 20,000 bill acceptance/dispense cycles or the machine may stop functioning . The rollers and transfer belts can be cleaned more often . NOTE: This procedure is performed in the Communications Mode . Figure 6 - 43 Cleaning Mode Calibration Procedure Begin the test by setting DIP Switch SW1 Switches 1 & 8 to ON and apply power to the unit . Press SW2 to Display “T15” Press SW3 to Begin Cleaning Process Insert the dedicated cleaning paper into the Bill Entry Slot . Once cleaning is complete, remove the paper from the Dispensing Slot . Press SW1 to End the Test . a b C L N c d T 1 5 NOTE: Make sure that “CLN” is displayed and initialization is complete before proceeding to next step! e NOTE: Insert only one piece of cleaning paper at a time . T 1 5 Figure 6 - 44 Applying Cleaner to Sheet NOTE: If a JCM Cleaning sheet is unavailable when cleaning is necessary, use a flat piece of substitute paper having a thickness of 0 . 22mm (0 . 0086614 inches) . WARNING: Use of a stronger alcohol percentage than 50% will damage the lenses and void the warranty . Figure 6 - 45 Inserting Wet Cleaning Sheet Entry Slot Exit Slot Cleaning Sheet NOTE: When a CPU Circuit Board has been replaced, the Counting Sensors must be re - calibrated . Caution: During adjustment, do not expose the Count Sensors to a bright extraneous light source!