JCM Part No . 960 - 000076R _ Rev . 1 © 2007, JCM - American Corporation 1 - 2 Section 1 World Bill Acceptor (WBA® - 1x/2x - SS & SS2) General Information Model Number Specifications Precautions The Figure 1 - 2 symbols are defined as follows: 1 . ( Type 1 ) Do not insert a torn, folded, or wet bill, as this action may cause a bill jam inside the unit . 2 . ( Type 2 ) Do not expose the unit to water . The unit contains several precision elec - tronic devices which can be damaged if water or any liquid is sprayed or spilled into the unit . 3 . ( Type 3 ) Do not install the unit into a dusty environment . Dust may affect and degrade the sensor’s performance . User Cautions 1 . Be sure to turn the power off before plugging or unplugging connectors . 2 . Firmly close the unit’s Transport path before applying power . 3 . When closing the unit, ensure all service door locks click into place . Make sure to open and close the unit’s bill path access ports gently, and take care that no dust or other foreign objects enter when opening the guide area . 4 . Do not allow inventory stock to endure high temperature, high humidity or a dusty environment . 5 . Do not throw the unit or allow it to fall to the ground . Improper handling may cause per - sonal injury and/or damage to the equipment . 6 . If the bill validator is dirty due to dust, foreign objects, or other such debris adhering to it, the bill acceptance rate will degrade . Use a soft, lint - free cloth and a mild non - abrasive soap and water solution to clean dust and debris from the bill path . Table 1 - 1   Model Number Specifications N o Model: WBA -   ** -   SS* -   ***(*) -   *** -   **              N o      (1) (2)     (3)       (4)(5)    (6,7,8)   (9) (1) Acceptor head type   1 . 1x Head (magnetic sensors enhanced)   2 . 2x Head (optical sensors enhanced) (2) CPU board type (3) Box type    SS    = SS Down Stacker (80mm width)    SS2 = SS Down Stacker (82mm width for Euro                Banknotes) (4) Country Code Refer to Table 1 - 6 on page 7 (5) Denominations accepted Relative to the Country Code programmed (Euro Examples) (6) Box capacity    4 = 400 note capacity    5 = 500 note capacity (standard)    A = 1000 note capacity (7) Faceplate *    0 = Without Faceplate (standard)    1 = With JCM standard WBA Faceplate (85mm wide) * . Contact your JCM Sales Representative for information concerning Faceplates, and other options available . (8) Guide Width (9) External Interface †    01 = ID001: Parallel Interface    02 = ID002: Pulse Interface    03 = ID003: Bidirectional Serial Interface (standard)    44 = ID044/045: Serial & Pulse Interface 0A2 = ID - 0A2: Serial & Pulse Selectable Interface † . Contact JCM for other Interface requirements .   0 . 1Mbit Flash ROM   1 . 1Mbit EPROM 2&4 . 4Mbit Flash ROM 3&5 . 4Mbit EPROM             Denomination Country Code €5 €10 €20 €50 €100 €200 €500 EUR1 X X X EUR2 X X X X EUR3 X X X X X EUR4 X X X X X X EUR5 X X X X X X X   1 = 66mm   2 = 70mm   3 = 75mm   4 = 80mm   5