JCM Part No . 960 - 000076R _ Rev . 1 © 2007, JCM - American Corporation 2 - 6 Section 2 World Bill Acceptor (WBA® - 1x/2x - SS & SS2) Installation/Operation DIP Switch Configurations Table 2 - 6 lists the default DIP Switch con - figurations for the WBA Right Side panel DIP Switch Block .    Table 2 - 6   DIP Switch Settings WBA Right Side Panel Switches Default Setting = ALL Switches are OFF Switch No . Switch ON Switch OFF 1 TITO * barcode coupon disabled TITO* barcode coupon enabled 2 $1 bill disabled $1 bill enabled 3 $5 bill disabled $5 bill enabled 4 $10 bill disabled $10 bill enabled 5 $20 bill disabled $20 bill enabled 6 $50 bill disabled $50 bill enabled 7 $100 bill disabled $100 bill enabled 8 TEST Mode NORMAL Mode * . TITO = Ticket In Ticket Out Table 2 - 6   DIP Switch Settings (Continued) WBA Right Side Panel Switches Default Setting = ALL Switches are OFF Switch No . Switch ON Switch OFF NOTE: DIP Switch settings may vary based on software changes related to the specific country using the WBA . Please contact you r local JCM Customer Representative for the latest setting information, or visit the JCM Website at www . jcm - american . com . Figure 2 - 9 WBA 1X - SS & 2X - SS Acceptor Head Lens Differences WBA 1X SS Acceptor Head Components Item #109 = LED Bushing Item #110 = Receiver (RE) Bushing Item #111 = Sensor Bushing (RE - 7AJ04A) WBA 2X - SS Acceptor Head Components Item #110 = Receiver (RE) Bushing Item #111 = Sensor Bushing (RE - 7AJ04A) WBA - 1X and WBA - 2X Head Sensor Lens Differences Figure 2 - 9 illustrates the WBA 1x - SS and 2X - SS Acceptor Head Lens Differences .