JCM Part No . 960 - 000076R _ Rev . 1 © 2007, JCM - American Corporation 2 - 7 Installation/Operation World Bill Acceptor (WBA® - 1x/2x - SS & SS2) Section 2 Retrieving Bills To retrieve WBA Cash Box deposited bills, perform the following steps: 1 . Push the Release Lever down (See Figure 2 - 10 a) to release the Cash Box from the frame, and pull the Cash Box forward as illustrated in Figure 2 - 10 b . 2 . Open the Cash Box door and retrieve the bills as illustrated in Figure 2 - 11 . Clearing a Bill Jam When a bill is jammed near the Bill Acceptor's entrance: 1 . Pull out on the tabs located on each side of the Acceptor as indicated by the small arrows in Figure 2 - 12 and 2 . Open the units Acceptor’s Cover (See Figure 2 - 12 a) . 3 . Remove the jammed bill (See Figure 2 - 12 b) . 4 . If the jammed bill cannot be removed by opening the Acceptor, pull up on the Transport Unit Open/Close Lever ( See Figure 2 - 13 a) 5 . Open the Transport Unit Cover (See Figure 2 - 13 b inset) and 6 . Remove the jammed bill (See Figure 2 - 13 c) . 1 . When a bill is jammed near the Cash Box inlet area, push down on the Cash Box Release Lever ( See Figure 2 - 14 a) and 2 . Pull the Cash Box out of the frame ( See Figure 2 - 14 b) and 3 . Remove the jammed bill (See Figure 2 - 14 c) . Figure 2 - 10 Removing the WBA Cash Box a b Figure 2 - 11 Retrieving Bills Figure 2 - 12 Clearing an Entrance Bill Jam a b Figure 2 - 13 Clearing a Transport Unit Bill Jam a b c