JCM Part No . 960 - 000076R _ Rev . 1 © 2007, JCM - American Corporation 4 - 1 WBA ® Series World Bill Acceptor (WBA ® - 1x/2x - SS & SS2) S e c t i o n 4 4   DISASSEMBLY/REASSEMBLY This section provides disassembly and reassembly instructions for the World Bill Acceptor Series (WBA) . This section contains the following infor - mation: •   Tool Requirements •   Primary Unit Disassembly •   Acceptor Unit Disassembly •   Transport Unit Disassembly •   Cash Box Disassembly Tool Requirements The following tools will be required to perform disassembly and reassembly: •   #1 & #2 Phillips Screwdriver •   Set of Jewelers Phillips Screw Drivers •   E - Clip (E - Ring) Plyers •   Needle Nose Plyers •   Tweezers Primary Unit Disassembly The following instructions are provided to perform an initial disassembly of the World Bill Acceptor’s primary parts . 1 . Pull down on the front round bar Release Latch ( See Figure 4 - 1 a) and pull the WBA Acceptor assembly forward and out of the unit ( See Figure 4 - 1 b) . 2 . Pull down the Transport Unit Release Lever ( See Figure 4 - 2 a) and pull the transport unit out of the assembly (See Figure 4 - 2 b) . 3 . Press down on the Cash Box Release Lever ( See Figure 4 - 3 a) and remove the Cash Box from the frame (See Figure 4 - 3 b) . Figure 4 - 1 WBA Acceptor Head Removal a) b) a) b) Figure 4 - 2 WBA Transport Unit Removal a) b) Figure 4 - 3 WBA Unit Cash Box Removal